PTFE Sleeve Adapter Sets For Coaxial Systems

With WILMAD's exclusive PTFE Sleeve Adapter Sets, the tubes you already have can be used as coaxial tubes very easily.

You will receive two supports with each adapter set. The upper support has a flange that lets it rest on top of the outer tube. The lower support fits snugly into the outer tube and has flats cut in the side to allow air out during insertion. Position the lower support to support the lower half of the inner tube and keep it out of the probe's Rfcoil.

The PTFE Sleeve Adapter Set allows you to use standard tube caps for many of the tubes. You don't need a cap for the outer tube; the upper support plugs the top of this tube.

You can create your own unusual coaxial sets. For example, hold the outer (annular) volume constant while changing the inner volume. Just use inner tubes of the same OD but different wall thickness.

Order the tubes seperately.

Note:Do not use PTFE Sleeve Adapter Sets in variable temperature studies.

Since PTFE expands and contracts much faster than glass, the fit of the adapters can be assured only at room temperature.