Product/Service

Ferrules for 360µm Tubing in 10-32 Coned Ports

Source: IDEX
Use these ferrules with any of the nuts listed in "Use With Parts" to directly connect 360µm OD fused silica or other capillary tubing into 10-32 threaded coned ports designed for 1/16" OD tubing.

Use these ferrules with any of the nuts listed in "Use With Parts" to directly connect 360µm OD fused silica or other capillary tubing into 10-32 threaded coned ports designed for 1/16" OD tubing.

For electrospray applications, try our M-215 Conductive Perfluoroelastomer Ferrule instead of graphite ferrules. Because of its elastomeric properties, you can reuse this ferrule through many tightening/retightening cycles — unlike most graphite ferrules. Like graphite ferrules, voltage can be applied through the metallic fitting's port block, allowing the voltage to translate to the flow path through the ferrule. You may also use this ferrule with a stainless steel nut in a plastic port by applying the voltage to the nut.

Our tests on 360µm fused silica and PEEK™ tubing show the M-215 will hold to at least 1,500 psi (103 bar), and the F-151 Kel-F® ferrule is pressure rated to 6,000 psi (414 bar). The M-215 is robust enough to withstand temperatures from -15°C to +260°C.

  • Direct connect capillary tubing to 10-32 ports designed for 1/16" OD tubing
  • Version for Mass Spec electrospray applications

Click here to download the micro flow catalog extract in pdf format.